CCVMQ - RICH LUX LOW LUSTRE LATEX ENAMEL (028 LINE)
- MSDS: CCVMQ
- Manufacturer: M A BRUDER AND SONS INC
- Product Name: RICH LUX LOW LUSTRE LATEX ENAMEL (028 LINE)
- National Stock Number: 8010-00D001267
Product Identification
Product ID:RICH LUX LOW LUSTRE LATEX ENAMEL (028 LINE)
MSDS Date:10/31/1992
FSC:8010
NIIN:00D001267
MSDS Number: CCVMQ
Responsible Party
BROMALL, PA 19008
US
Emergency Phone: 215-353-5100
Info Phone: 215-359-3635
Cage: 85519
Contractor
Telephone: 610-353-5100;610-359-3635
Cage: 85519
Ingredients
TITANIUM DIOXIDE
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 11-30%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST; 9596
SILICA, CRYSTALLINE - QUARTZ
CAS: 14808-60-7
RTECS: VV7330000
Fraction By Weight: 1-10%
OSHA PEL SEE TABLE Z-3
ACGIH TLV: 0.1 MG/M3 RDUST;9596
TEXANOL,
CAS: 25265-77-4
RTECS: UF6000000
Fraction By Weight: 1-10%
ETHYLENE GLYCOL (SARA 313) (CERCLA)
CAS: 107-21-1
RTECS: KW2975000
Fraction By Weight: 1-10%
ACGIH TLV: C STEL39PPM,A4,VAP96
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
PROPYLENE GLYCOL
CAS: 57-55-6
RTECS: TY2000000
Fraction By Weight: 1-10%
WATER
CAS: 7732-18-5
RTECS: ZC0110000
Fraction By Weight: >3%
ACRYLIC COPOLYMER
Fraction By Weight: >3%
STYRENE ACRYL COPOLYMER
Fraction By Weight: >3%
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALE-IRRITATION OF
RESPIRATORY TRACT. PROLONGED INHALATION MAY LEAD TO MUCOUS MEMBRANE
IRRITATION. SKIN-IRRITATION OF SKIN. PROLONGED OR REPEATED CONTACT
CAN CAUSE DERMATITIS. EYE-IRRITATION OF EYES. PROLONGED OR
REPEATED CONTACT CAN CAUSE BLURRED VISION, CORNEAL INJURY.
Explanation of Carcinogenicity:SILICA, CRYSTALLINE-QUARTZ:IARC
MONOGRAPHS, SUPPLEMENT. VOL 7, PG 341, 1987: GROUP 2A. NTP 7TH
ANNUAL REPORT.
Effects of Overexposure:INHALATION-MAY LEAD TO DROWSINESS, AND/OR
LIGHT-HEADEDNESS, HEADACHE, NAUSEA. INGESTION-AMOUNTS INGESTED
INCIDENTAL TO CONSUMER AND INDUSTRIAL HANDLING ARE NOT LIKELY TO
CAUSE INJURY; HOWEVER, INGESTI ON OF LARGE AMOUNTS COULD CAUSE
SERIOUSINJURY.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE & SUPPORT CONTINUED
BREATHING. HAVE TRAINED PERSON GIVE OXYGEN IF NEDED. GET EMERGENCY
AID. SKIN:WASH OFF QUICKLY WWITH PLENTY OF WATER, THEN SOAP &
HWATER; REMOVE S OILED CLOTHES. EYES: FLUSH IMMEDIATELY WITH LARGE
AMOUNTS OF WATER, ESPECIALLY UNDER LIDS, FOR AT LEAST 15 MIN.
OBTAIN MEDICAL AID. INGEST:IF SWALLOWED, OBTAIN MEDICAL TREATEMNT
IMMEDIATELY.
Fire Fighting
Flash Point:NON FLAMMABLE
Extinguishing Media:DRY CHEMICAL OR FOAM.
Fire Fighting Procedures:NON-FLAMMABLE. WATER MAY BE USED TO COOL AND
PROTECT EXPOSED CONTAINERS.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY BURST IF EXPOSED TO
EXTREME HEAT OR FIRE.
Accidental Release
Spill Release Procedures:COLLECT IN CONTAINER FOR DISPOSAL, ACCORDING
TO HEALTH AND ENVIRONMENTAL REGULATIONS. CLEAN UP WITH WATER BEFORE
ALLOWING TO DRY.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE BELOW 100 DEGREE F. KEEP FROM
FREEZING.
Other Precautions:DO NOT TAKE INTERNALLY. KEEP OUT OF REACH OF
CHILDREN.
Exposure Controls
Respiratory Protection:CONTROL ENVIRONMENTAL CONCENTRATIONS BELOW
APPLICABLE STANDARDS. WHERE RESPIRATORY PROTECTION IS REQUIRED, USE
ONLY NIOSH/MSHA APPROVED RESPIRATORS IN ACCORDANCE WITH OSHA
STANDARD 29 CFR 1910.134.
Ventilation:MAINTAIN ADEQUATE VENTILATION TO ENSURE AIR ENTRY DURING
APPLICATION AND DRYING TO PREVENT BUILD-UP OF VAPORS.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:SAFETY GLASSES OR GOGGLES.
Other Protective Equipment:SKIN CREAM (IF NEEDED). EYE WASH, SAFETY
SHOWER.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health
DOT: NOT REGULATED.
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:>212F,>100C
Evaporation Rate & Reference:SLOWER THAN ETHYL ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:59-70
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZERS, ACIDS, BASES, AMINES.
Stability Condition to Avoid:ELEVATED TEMPERATURES. CONTACT WITH
OXIDIZING AGENTS.
Hazardous Decomposition Products:IF INVOLVED IN FIRE (FROM OTHER
SOURCES) COULD CONCEIVABLY RESULT IN RELEASE OF CARBON DIOXIDE AND
CARBON MONOXIDE.
Disposal
Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.